PDQ OWNERS FORUM

I had great service from ZORO.com Great web page.
Brian

New issue. The engine would not start, sometimes nothing, sometimes just click. It is not mechanical, I have fully charged batters. With help we diagnosed corroded wire harness from engine to ground stud. Cutting back the outer jacket I could not find tinned wire , could not find copper wire, just b...

Anyone actually replaced the rubber gasket? Do you have any recommendations. How to remove the old gasket with out causing damage?
Brian
032032
MIDORI

I believe someone was looking for hinges, I saw a set on Craiges List Fort Myers Florida Dec 25, 2022. they look like they would work. Hope this helps.
Brian
Midori

Any suggestions or recommendations when rewiring the mast? Does anyone have a wiring diagram for the mast?
Thanks
Brian
sv MIDORI 32032

Thank you Double Dutch.
I ordered the track system today and look forward to using it.
Brian

Anyone with experience of installing and using a sail track system such as Tides Marine? Any comments or suggestions please.

The idea from Thinwater has merit. Now the www.Pompanettellc.com page has 2 hinge sets of interest, Low profile P2000-44 and Pin & hinge P2000-20hp. I could look into those. Brian 32032

Photo

I will keep you in the loop. MIDORI has damage to both the frame and window hinge. I will attempt to post a photo.
SV MIDORI 32032

Thank you James. I will contact Pompettellc.com to see if a replacement is available. i do not have any knowledge of 3d printing, the cost or ability to have the outside frame reproduced? Thank you for your response James. SVMIDORI 32032

I have searched the PDQ and PDQ 32 topics for information on cockpit ports. There are 3 on each cockpit, one each in the stateroom and one into the salon. I do recall reading some feedback on these ports but cannot locate any information. The hinge setup on all three are failing. I would appreciate ...

Good afternoon Jerry. I did my own installation. On this install I used Dyneema. I found the Dyneema easy to work with but as mentioned by Drew Fry, pay attention for unexpected fraying. I used "D" shackles rather than looping the Dyneema threw the fiberglass. I found getting a tight tramp...

I chose Dyneema because it had been recommended as being easier to use. I recommended the use of Dyneema because in my use I found it to be much easier to work with. Fortunately I do not have direct contact with fiberglass, the hull to net is a D shackle to a stainless grommet. I thank you for the i...

MIDORI PDQ 32 tramp. I am pleased with the new tramp, Matt at Sunrise Yacht was excellent to work with. The all in price with freight and tax was just under 1,200. My old tramp would not be reusable on a PDQ. Definitely go for the Dema lacing. Sorry for the delay, I was out of town when I received y...