Search found 692 matches

by amytom
Tue Jun 04, 2019 3:05 pm
Forum: PDQ Capella (PDQ 36) Forum
Topic: Remove hot water heater
Replies: 13
Views: 300

Re: Remove hot water heater

The picture shows a clean molded edge around the cabinet. The PDQs I’ve been on usually has a flat fiberglass surface with a cabinet frame attached either via screws or glue. Can you attach another picture showing the outside of the cabinet and how the door is attached?
by amytom
Tue Jun 04, 2019 8:53 am
Forum: PDQ Capella (PDQ 36) Forum
Topic: Remove hot water heater
Replies: 13
Views: 300

Re: Remove hot water heater

Hard to tell from picture but can the locker frame be removed?
by amytom
Fri Jan 25, 2019 10:58 pm
Forum: Forum Tricks and Tips
Topic: Forum Software notes - from Admin
Replies: 4
Views: 943

Re: Forum Software notes - from Admin

Thank you both for keeping it running.
by amytom
Mon Jan 07, 2019 7:43 am
Forum: PDQ Capella (PDQ 36) Forum
Topic: Electric Choke Switch Options
Replies: 2
Views: 579

Re: Electric Choke Switch Options

I think a few of the later model 9.9’s had an electric choke solenoid on or off not the thermoelectric of the early models.
Yamaha had some ignition switches that if you pressed the key in further than just inserting it would cycle the choke on. Maybe you can find one of those?
by amytom
Mon Sep 03, 2018 11:13 pm
Forum: Outboard Engines
Topic: Parts available for vintage 9.9’s.
Replies: 1
Views: 937

Re: Parts available for vintage 9.9’s.

Wow! No takers?
A full running engine minus lower unit and box of parts including carbs, starter, fuel pump kit, carb kit, props, regulator, ecm module, coils, etc...

All free to any of the PDQ family that can pick them up in Kissimmee.
by amytom
Sun Sep 02, 2018 10:22 pm
Forum: Outboard Engines
Topic: Parts available for vintage 9.9’s.
Replies: 1
Views: 937

Parts available for vintage 9.9’s.

Anyone needing parts for vintage Yamaha 9.9’s? I have a complete engine running well minus the lower unit. Also have a box of spares.
Just bought a replacement from Andy at Shipyard Island.
by amytom
Fri Jul 27, 2018 3:13 pm
Forum: Outboard Engines
Topic: Older lower unit
Replies: 0
Views: 550

Older lower unit

I have one of the original T9.9's 1998 vintage. On my last trip I thought it had died but when I tore into it today I discovered it was just the lower unit main shaft seal had failed and the gears had run on seawater lubrication for too long. Looking at the engine itself the oil screen did have meta...
by amytom
Tue Jul 24, 2018 7:43 pm
Forum: PDQ Altair (PDQ 32) Forum
Topic: Rear cockpit enclosure for PDQ 32?
Replies: 10
Views: 1713

Re: Rear cockpit enclosure for PDQ 32?

As Drew mentioned above the rain doesn't blow in while at anchor and it is a bit of a pain to put up and take down. I over did it though, three layers screen, clear vinyl, and sunbrella supreme cover. Too heavy and bulky to just leave in place rolled up. If I lived on board at this point I would pro...
by amytom
Fri Jul 13, 2018 9:19 pm
Forum: PDQ Capella (PDQ 36) Forum
Topic: PDQ 36 Rudders
Replies: 10
Views: 3464

Re: PDQ 36 Rudders

Same thing on the 32’s. I not only created the access ports but put bilge pumps in the areas wired to a manual switch.

After adding a few layers of glass to the stbd post seems most of the flooding in that area is from rainwater entering the lazarette.
by amytom
Fri Jul 13, 2018 9:15 pm
Forum: PDQ Altair (PDQ 32) Forum
Topic: Autohelm ST4000+ Problem
Replies: 7
Views: 1455

Re: Autohelm ST4000+ Problem

Read the manual about the gain control and response profile.
That may be your issue.
by amytom
Thu Jul 05, 2018 3:16 pm
Forum: PDQ Altair (PDQ 32) Forum
Topic: PDQ32+
Replies: 23
Views: 7580

Re: PDQ32+

Post trip update- Had our first extended trip on the boat since the upgrades. Wow! what a difference. Sailed from Melbourne to Key Largo and back with some diving and playing in the keys while down there. Solar - adding the new panels on the arch made it so in a week of sailing with 6 people on boar...
by amytom
Thu Jul 05, 2018 2:47 pm
Forum: PDQ Altair (PDQ 32) Forum
Topic: Rear cockpit enclosure for PDQ 32?
Replies: 10
Views: 1713

Re: Rear cockpit enclosure for PDQ 32?

We made a very nice rear enclosure for our boat and used it one winter. It's been in the attic ever since. Several hundred dollars of cloth and dozens of hours labor wasted.
by amytom
Tue Jun 05, 2018 4:55 pm
Forum: Outboard Engines
Topic: Key switch replacement
Replies: 3
Views: 1434

Re: Key switch replacement

Works great, not quite as refined as the original Yamaha but the price makes up for it.

See my answer to your other post too; hopefully it will help.
by amytom
Tue Jun 05, 2018 4:54 pm
Forum: Outboard Engines
Topic: Electric start
Replies: 2
Views: 876

Re: Electric start

First of all I see you list as a PDQ32+; is this Drew's old boat? Thought we were the only two with the extensions. For the starter motor, sounds like the starter or solenoid shorted out when you had your line wrap (that happens to all of us eventually). After the new fuse is in is the starter wont ...
by amytom
Mon Jun 04, 2018 7:02 am
Forum: PDQ Altair (PDQ 32) Forum
Topic: PDQ32+
Replies: 23
Views: 7580

Re: PDQ32+

Check out the Atlantic towers website for the weight and pictures of the mounting hardware. If you search my posts on this forum you’ll find pictures of our install. We still have the aft rail in place but are working towards getting rid of it (as soon as we figure out where to put dinghy engine). W...