Page 1 of 1

Need some information

Posted: Wed Mar 15, 2017 6:07 pm
by Aries
I recently bought a PDQ36 in Grenada, there are a host of items to fix some of which I hope to start on in a couple of weeks when visiting the boat. Now Grenada is far away and chandleries are limited and a lot of items have to be pre-ordered, so I am hoping someone can provide some guidance on some of the items I need, they are as follows:
Fuel filler hose (deck to tank), inside diameter and (less important) length of hose
Want to replace all the sanitory (blackwater) hoses, inside diameter and approximate total length needed
What are the typical gas inline and Racor filters used for the Yamaha 9.9 HP motors (p/n please)
I have been able to place most of the other items, but would like to address the above unknowns (to me) when I am there next month and would need to order these components.
Help most appreciated
Ben Naude
PDQ 36060

Re: Need some information

Posted: Wed Mar 15, 2017 8:53 pm
by Jim_D
Hey Ben;
I replaced the sanitation hoses in our PDQ36 in the fall. I ordered 20 feet of 1-1/2" Raritan Sani / Flex Sanitation Hose. That completed the run from the head back to the sanitation tank; hose from sanitation tank to deck fitting. Those were the hoses I wanted done. We still had about four to five feet of hose left which could have replaced the other hoses in the aft compartment.


Re: Need some information

Posted: Thu Mar 16, 2017 6:07 am
by SecondWind
Send a private message to mikeandrebecca (Zero to cruising) who are members on this forum. They have spent a lot of time in Grenada and can probably help you with local sources.

Re: Need some information

Posted: Fri Mar 17, 2017 9:32 am
by Aries
Thanks Jim, Terry will PM Mike and Rebecca.