I recently read the Newsletter on the replacement trifold mattress. I have not put them in but was wondering about retaining the 1" spring plastic that is under the mattress. I would appreciate any experience others have had with the trifold mattresses.
Dennis and Cindy Strecker
Hull 95
Replacement Mattresses
Re: Replacement Mattresses
i'll add to this. we have a 2003. i assume that the bunks on all years are the same.
my questions are: 1) how closely does this mattress match the length & width of the original? 2) on ours, the rear edge has a tapered thickness to match the curve of the hull. how does the new mattress conform? if you're sleeping on the rea, near the hatch, do you feel like you're rolling down a hill?
my questions are: 1) how closely does this mattress match the length & width of the original? 2) on ours, the rear edge has a tapered thickness to match the curve of the hull. how does the new mattress conform? if you're sleeping on the rea, near the hatch, do you feel like you're rolling down a hill?
john & diane cummings
duetto mv34 #23
duetto mv34 #23
Re: Replacement Mattresses
You would want to continue using the plastic air vent under any replacement mattress to prevent condensation. I don't know anything about the replacement mattress in the newsletter. We do have some Dormeo 2" toppers on our original mattresses. They add to the comfort without making it too difficult to fold back for engine access. But, they probably cost as much as the mattresses in the newsletter!
Julie & Chris Head
"Headway"
2006 MV 34 #86 100hp
"Headway"
2006 MV 34 #86 100hp
-
- deckhand
- Posts: 21
- Joined: Tue Jul 28, 2020 8:29 pm
- Location: Channel Islands Harbor
Re: Replacement Mattresses
We used https://www.mattressinsider.com/ custom folding mattress shipped right to you.
Mark & Dea Goldsmith
BLACKBIRD
PDQ 34-114
BLACKBIRD
PDQ 34-114
-
- skipper
- Posts: 64
- Joined: Fri Feb 08, 2019 3:59 pm
Re: Replacement Mattresses
I found the mattress to be good quality. The mattress fits like the old one except for the aft taper. I did not noticed that the taper made any difference. You can’t even notice that the mattress is not tapered when layer out for sleeping. I doubt it will make any difference when sleeping. As far as the engine access for inspections, I find the old mattress is better because when folded it clears the wooden engine cover completely. With the trifold you have to completely fold the mattress into a stack. However if you have to do any work on the engine you do have more room with the trifold and it is a lot easier to completely remove the mattress. I leave the mattress folded when I am not sleeping on the boat. For the price $159 now, it is a bargain.
Dennis
Hull 95
Dennis
Hull 95
-
- skipper
- Posts: 64
- Joined: Fri Feb 08, 2019 3:59 pm
Diesel Outboards and Sharrow Marine Props.
I know the discuss has come up about replacing the engines. Just wanted to pass on a YouTube video I saw this morning titled “ Sharrow Marine- Showdown in Paradise” by BoatTEST.com. The boat tested was a powercat fitted with outboard diesels. It discussed the problems with replacing inboard engines. I believe the engines were 300 HP diesels and the boat was 50+ feet. The Sharrow Props performance are phenomenal. If and when I need engine replacement I think I might consider outboards.
Dennis and Cindy
Hull 95
Dennis and Cindy
Hull 95