I just bought a 2001 T9.9 tiller model that I have to convert to remote. I have the elec. harness (6G8-82590-00-00), but I'm not sure where to connect to. If I unplug some existing connections to plug in the harness wires, what happens to the old wires?
Can't seem to figure it out.
Thanks, Marc
Need wiring help
-
Marc Gershel
- admiral
- Posts: 204
- Joined: Sat May 08, 2004 1:58 am
- Location: Philadelphia.Pa 36021
-
amytom
- admiral
- Posts: 694
- Joined: Fri Oct 05, 2007 10:57 am
- Location: Orlando, FL S/V DogHouse PDQ32009
Re: Need wiring help
Just tuck them away, maybe coat them in electronics grease to prevent corrosion just in case you want to convert back later.
Re: Need wiring help
Marc,
If you connect the harness as in the diagram, you are good to go. If the engine has a neutral switch, I would bypass it and attach directly to the starter relay. (Brown wire) Also the Blue wire should go to the Y/R wires junction after removing the Y/R wire that goes to the oil pressure indicator lamp on the engine. I just tuck the left over wires out of the way with a small wire tie.
Chet
If you connect the harness as in the diagram, you are good to go. If the engine has a neutral switch, I would bypass it and attach directly to the starter relay. (Brown wire) Also the Blue wire should go to the Y/R wires junction after removing the Y/R wire that goes to the oil pressure indicator lamp on the engine. I just tuck the left over wires out of the way with a small wire tie.
Chet
- Attachments
-
- T9.9 Wiring Diag.jpg (216.25 KiB) Viewed 6571 times
-
Marc Gershel
- admiral
- Posts: 204
- Joined: Sat May 08, 2004 1:58 am
- Location: Philadelphia.Pa 36021
Re: Need wiring help
Chet,
Thanks, just what I was looking for. Can always count on you.
Marc
Thanks, just what I was looking for. Can always count on you.
Marc