Pulley for manual tilt

Post here for issues with outboard engines (i.e Yamaha 9.9) on PDQ yachts
User avatar
MIDORI
skipper
skipper
Posts: 70
Joined: Sun Oct 22, 2006 1:13 pm
Location: Manitoba Canada

Pulley for manual tilt

Postby MIDORI » Fri Nov 22, 2013 4:03 pm

Does anyone have a photo to show the location for mounting the pulley on the cavitation plate for manually lifting the engine?

32032
MIDORI
Brian

amytom
admiral
admiral
Posts: 665
Joined: Fri Oct 05, 2007 10:57 am
Location: Orlando, FL S/V DogHouse PDQ32009

Re: Pulley for manual tilt

Postby amytom » Sat Nov 23, 2013 12:21 am

Don't have a picture handy but...

The four nuts that hold the lower unit on, one of the rear nuts taken off and a bolt hanger (the climbing type) added in. The pulley then goes on the bolt hanger.

Let me know if you need more I can probably get a pic tomorrow.

User avatar
jimlong
admiral
admiral
Posts: 125
Joined: Mon Jan 14, 2008 9:29 pm
Location: Albuquerque, Nm. (Ocean Dreamer 36071)
Contact:

Postby jimlong » Sat Nov 23, 2013 8:37 am

IMG_8618.JPG
Tom pretty well summed it up. This pic was taken off of our PDQ36
Last edited by jimlong on Sat Nov 23, 2013 8:39 am, edited 1 time in total.

User avatar
MIDORI
skipper
skipper
Posts: 70
Joined: Sun Oct 22, 2006 1:13 pm
Location: Manitoba Canada

Re: Pulley for manual tilt

Postby MIDORI » Sat Nov 23, 2013 8:39 am

Excellent, thank you.
Brian

Rich Tanner 36083
1st mate
1st mate
Posts: 36
Joined: Sat May 08, 2004 10:53 am
Location: Titusville

Re: Pulley for manual tilt

Postby Rich Tanner 36083 » Thu Feb 27, 2014 7:15 pm

Hi Brian
One thing I did was move the hardware to the forward bolt on the cavitation plate. This raises the lower end a couple of inches higher than the factory location and kept them out of the water
Rich


Return to “Outboard Engines”

Who is online

Users browsing this forum: No registered users and 1 guest