Page 1 of 1

Pulley for manual tilt

Posted: Fri Nov 22, 2013 3:03 pm
by MIDORI
Does anyone have a photo to show the location for mounting the pulley on the cavitation plate for manually lifting the engine?

32032
MIDORI

Re: Pulley for manual tilt

Posted: Fri Nov 22, 2013 11:21 pm
by amytom
Don't have a picture handy but...

The four nuts that hold the lower unit on, one of the rear nuts taken off and a bolt hanger (the climbing type) added in. The pulley then goes on the bolt hanger.

Let me know if you need more I can probably get a pic tomorrow.

Posted: Sat Nov 23, 2013 7:37 am
by jimlong
Tom pretty well summed it up. This pic was taken off of our PDQ36
Tom pretty well summed it up. This pic was taken off of our PDQ36

Re: Pulley for manual tilt

Posted: Sat Nov 23, 2013 7:39 am
by MIDORI
Excellent, thank you.

Re: Pulley for manual tilt

Posted: Thu Feb 27, 2014 6:15 pm
by Rich Tanner 36083
Hi Brian
One thing I did was move the hardware to the forward bolt on the cavitation plate. This raises the lower end a couple of inches higher than the factory location and kept them out of the water
Rich