Shift Linkage Problems
-
- admiral
- Posts: 270
- Joined: Sat May 08, 2004 1:30 pm
- Location: Washington, NC (34108)
Shift Linkage Problems
I just had a problem that may be of interest to some. My shift linkage jammed and would not allow the shift lever to move. I mistakenly started at the shift lever to investigate the problem. After removing the entire shift mechanism, I determined the problem to be at the motor. The end of the control cable is composed of two sleeves and the inner one had corroded and was jammed in the outer one. After removing the cables from the motor I could twist the sleeves and release the jam and then grease them to restore movement. All of this could have been prevented if I had greased these on a frequent basis. I also broke the neutral start switch in the shift mechanism when I pulled the shift levers from the mount.... Anyone have an idea where I can get a replacement?
Ron McDaniel
TK III 34108
TK III 34108
-
- admiral
- Posts: 270
- Joined: Sat May 08, 2004 1:30 pm
- Location: Washington, NC (34108)
-
- admiral
- Posts: 204
- Joined: Sat May 08, 2004 1:58 am
- Location: Philadelphia.Pa 36021
Type of Grease
What type of grease do you recommend using on the cables?
-
- admiral
- Posts: 270
- Joined: Sat May 08, 2004 1:30 pm
- Location: Washington, NC (34108)