Outboard Flushing
-
- deckhand
- Posts: 19
- Joined: Sat May 08, 2004 10:29 am
- Location: Fernandina Beach (36099)
- Contact:
Outboard Flushing
What does the POA suggest for techniques & frequency of flushing the outboards? Owners manual's usually recommend after each use in salt water. Seems unlikely given outboard mounting location, crusing areas, etc.
Mike,
I find it almost immpossible to flush these engines after use unless you want to get into the water under the boat to put the "C-clamps" on the lower units and hook them to a hose.
I did see one interesting article recently which I intend to try. The writer took a large plastic wastebasket and attached a "swimming noodle" around the top of it just under the lip. He then put fresh water into it while holding it in the saltwater until almost full. Using a rope tied to the top of the basket he maneuvered the basket under the raised motor. He then lowered the motor into the fresh water and ran the engine (at neutral idle) to flush it.
Chet White
Allezcat 36010
I find it almost immpossible to flush these engines after use unless you want to get into the water under the boat to put the "C-clamps" on the lower units and hook them to a hose.
I did see one interesting article recently which I intend to try. The writer took a large plastic wastebasket and attached a "swimming noodle" around the top of it just under the lip. He then put fresh water into it while holding it in the saltwater until almost full. Using a rope tied to the top of the basket he maneuvered the basket under the raised motor. He then lowered the motor into the fresh water and ran the engine (at neutral idle) to flush it.
Chet White
Allezcat 36010
Yamaha Flushing
Mike,
I purchased 2 flush adapters from Yamaha - removed the flush plugs and installed them - I then attached a sort piece of hose with a shut off valve at the end and ran them up the back of the motor tied on with some large wire ties. Now I can flush the engines any time I want and even add Salt Away by just attaching a hose while at the dock - Easy, neat, and simple. Roger Wood
I purchased 2 flush adapters from Yamaha - removed the flush plugs and installed them - I then attached a sort piece of hose with a shut off valve at the end and ran them up the back of the motor tied on with some large wire ties. Now I can flush the engines any time I want and even add Salt Away by just attaching a hose while at the dock - Easy, neat, and simple. Roger Wood
Flushing Yamaha's
Chet - That's a good question - and I really don't know except that when I taste the water coming out of the flow indicator it is completly fresh (at least to taste) It may be that the flush entrance is closest to the intake of water. In either case it seems to work, and is easier than any other method I've come across. Roger
-
- admiral
- Posts: 204
- Joined: Sat May 08, 2004 1:58 am
- Location: Philadelphia.Pa 36021
-
- deckhand
- Posts: 16
- Joined: Mon May 10, 2004 6:19 pm
- Location: Florida