Does anyone have a photo to show the location for mounting the pulley on the cavitation plate for manually lifting the engine?
32032
MIDORI
Pulley for manual tilt
Pulley for manual tilt
Brian
-
- admiral
- Posts: 694
- Joined: Fri Oct 05, 2007 10:57 am
- Location: Orlando, FL S/V DogHouse PDQ32009
Re: Pulley for manual tilt
Don't have a picture handy but...
The four nuts that hold the lower unit on, one of the rear nuts taken off and a bolt hanger (the climbing type) added in. The pulley then goes on the bolt hanger.
Let me know if you need more I can probably get a pic tomorrow.
The four nuts that hold the lower unit on, one of the rear nuts taken off and a bolt hanger (the climbing type) added in. The pulley then goes on the bolt hanger.
Let me know if you need more I can probably get a pic tomorrow.
-
- 1st mate
- Posts: 38
- Joined: Sat May 08, 2004 10:53 am
- Location: Titusville
Re: Pulley for manual tilt
Hi Brian
One thing I did was move the hardware to the forward bolt on the cavitation plate. This raises the lower end a couple of inches higher than the factory location and kept them out of the water
Rich
One thing I did was move the hardware to the forward bolt on the cavitation plate. This raises the lower end a couple of inches higher than the factory location and kept them out of the water
Rich