Interior salon window trim
Interior salon window trim
Well we tackled replacement of the trim around the salon windows last weekend and am pleased to report that it is easy. I purchased a sheet of Seaboard (20" x 96", $105) from Hamilton Marine and set up some jigs on the table saw to mill the shapes. The original face flange is 5/8" but I used 1/2" and it covered fine. The job is easier with two people but otherwise just use a heat gun and bend into place. BTW Simon was right in that most of the board ended up in a pile of shavings on the shop floor. I think I'll have a little left for some shelving project in the galley.
Bob Johnson
Hull 36045
Peace
Hull 36045
Peace
- Lady of the Lake
- Site Admin
- Posts: 626
- Joined: Wed Dec 22, 2004 1:37 pm
- Location: Punta Gorda, FL (36015)
- Contact:
Re: Interior salon window trim
Pics?
Sam and Gina Densler
s/v Lady of the Lake
PDQ36 Hull #15
Punta Gorda, FL
s/v Lady of the Lake
PDQ36 Hull #15
Punta Gorda, FL
Re: Interior salon window trim
I'm heading for the boat and I take a few.
Bob Johnson
Hull 36045
Peace
Hull 36045
Peace