RIB for PDQ 36
Posted by Mike Murray on March 11, 2004 at 14:43:00:
My wife and I are about to order a Capella and plan to get a RIB. Does anyone know the max
size that fits between the hulls?
Posted by Mike Murray on March 12, 2004 at 04:43:00:
In Reply to: RIB for PDQ 36 posted by Mike Murray on March 11, 2004 at 14:43:00:
One additional question. Where is the best spot to stow the outboard for the dink? Does it
require somethin like a St Croix crane?
Posted by Rich Tanner on March 12, 2004 at 16:49:00:
In Reply to: Re: RIB for PDQ 36 posted by Mike Murray on March 12, 2004 at 04:43:00:
I have an Avon 10'2" RIB aboard. It fits snugly, with some scuffing and minor gel coat
damage if I am not careful raising it. But, I find it worthwhile to have a 10' dink. If you
removed the motor prior to raising the dink you would avoid the damage, but as I raise the
dink every night I chose not to.
Posted by Rick Gordon on March 25, 2004 at 11:34:00:
In Reply to: Re: RIB for PDQ 36 posted by Rich Tanner on March 12, 2004 at 16:49:00:
I have an Apex 10L, with a Mercury 9.9 two stroke. It fits beautifully between the hulls,
and is much lighter than most competitors. I leave the engine on all the time, although I
might take it off if I were headed back to Bermuda.
RIB for PDQ 36
-
- admiral
- Posts: 270
- Joined: Sat May 08, 2004 1:30 pm
- Location: Washington, NC (34108)
I have an AB 2.90VL. It is about 9ft 6 in and weighs 110 lbs. It cost $2300 at the Annapolis boat show. It fits perfectly with the engine. I use a Yamaha 8HP 2 cycle that weighs 62 lbs. It will plane with my wife and I aboard but if I had to do it again I would et a 15 HP. The extra HP would come in handy when both of us are in the dingy and we have to carry a couple jugs of water or fuel. I also added a 6 part block and tackle on the stern end of the dingy davits. It is much easier to lift now.
-
- deckhand
- Posts: 19
- Joined: Sat May 08, 2004 10:29 am
- Location: Fernandina Beach (36099)
- Contact:
- Ed Ellis
- admiral
- Posts: 168
- Joined: Mon May 17, 2004 10:48 pm
- Location: Soldier Creek / Perdido Bay, AL
I have a 10' Caribe RIB and had the same "snug fit/scuffing problem. I found that if you hoist the rib so that it's bow is on the starboard side of the PDQ, and then deflate the air chamber on the rear port side of the rib, it fits exceptionally well, plus no scuffing. You don't have to completely deflate the chamber, but rather deflate it enough so that it's mushy. Re-inflating takeas about 1 minute. ESE
Ed & Linda Ellis
Tranquility
Tranquility